To Next PageTo Next PageWhy does zoom or focus not work on my JVC D-ILA DLA-VS3000G?
If the zoom or focus function does not work on your JVC Projector, and the lens has been replaced, the lens may not work depending on its position. While at the Focus / Zoom adjustment screen, press and hold the J or K key for 2 seconds or longer. Doing so will allow the lens to recover from this condition.
What to do if the video image does not appear on my JVC Projector?
If the JVC Projector's video image doesn't appear, make sure the correct external input is selected. Also, verify that the AV device or PC is turned on and playing video, and that it's properly connected. Finally, ensure the correct signals are being output from the AV device or PC.
Why does my JVC D-ILA DLA-VS3000G Projector power shut down automatically?
If your JVC Projector shuts down automatically, it might be due to the “Off Timer” being configured. Set “Off Timer” to “Off”. Also, ensure that the air inlets and exhaust vent are not blocked by leaving proper clearance during installation. Lastly, a large amount of dirt attached to the sponge filter can cause this issue; remove the dirt using a vacuum cleaner.
How to fix a JVC Projector remote control that is not working?
If the remote control for your JVC Projector isn't working, first check if the batteries are correctly loaded, matching the polarities. If they are, try replacing them with new batteries. Ensure there are no obstructions between the remote control and the remote sensor, and make sure you're not holding the remote too far away from the unit during use.
What to do if my JVC D-ILA DLA-VS3000G Projector power is not supplied?
If your JVC Projector is not receiving power, ensure the power cord is firmly inserted into the plug. Also, check if the unit is in Cool-down mode; if so, wait for it to exit Cool-down mode before attempting to turn the power on again.
Why is the projected image from my JVC D-ILA DLA-VS3000G Projector so dark?
If the projected image on your JVC Projector is dark, check the laser light source time in the “Information” menu. If 20,000 hours have elapsed, the brightness will be half the brightness at shipment. Increase the value of the “Aperture” setting. Also, increase the value of the “LD Current” setting.
Why are the colors unnatural on my JVC D-ILA DLA-VS3000G Projector?
If the colors appear unnatural on your JVC Projector, ensure that the color space of the input signal is correctly set by adjusting the “Color Space” for “Input Signal”. Adjust “Color” and “Tint” accordingly. Also, verify that the AV device or PC is properly connected.
General| Category | Projector |
|---|---|
| Technology | D-ILA |
| Native Resolution | 4096 x 2160 |
| Brightness | 3000 ANSI Lumens |
| Zoom Ratio | 2.0x |
| Lens Shift | Horizontal |
| Inputs | HDMI, RS-232C |
| Dimensions | 500 x 234 x 545 mm |
