JVC D-ILA DLA-VS3000G - Remote Code and Software Management

Remote Code
For changing the remote control code.
Setting Description
A Change the remote control code from “B” to “A”.
B Change the remote control code from “A” to “B”.
0
You need to configure the remote control according to the settings of this unit.
On the remote control unit, press the [MENU] and [BACK] buttons at the same time for three seconds or longer to
switch the code.
0
The backlight of the remote control blinks 3 times: change the remote control code to “A”
0
The backlight of the remote control blinks 2 times: change the remote control code to “B”
0
If the setting differs between this unit and the remote control, the “STANDBY/ON” indicator blinks in green when
receiving the remote control code.
LIGHT
STANDBY/ON
WARNING
ANDBY/O
(Green)
Hide Mode
For reducing the power consumption through suppressing the current supply for the LD block when the [HIDE] button
is pressed to hide the image temporarily.
Setting Description
Off Do not suppress the current supply when the [HIDE] button is pressed to hide the
image temporarily.
On Suppresses the current supply when the [HIDE] button is pressed to hide the image
temporarily.
Software Update
For performing a software update.
For the latest information on the software, refer to https://www3.jvckenwood.com/english/download/.
44
Adjust/Set