23
English
To stop while recording, press 7.
The tape stops after 4 seconds.
To remove the cassette, press 0 on the unit.
When recording discs
A 4-second blank is automatically made on the tape before each
track. To record without the blank, follow the procedure below:
1
Load discs you want to record into the 5-CD Changer.
2
Press DISC SELECT on the unit to select the disc number you
have loaded.
3
Press #/8 CD on the unit twice so that disc playback is paused.
• If the pausing position is not “0:00,” you can skip back to
“0:00” by pressing 4 DOWN on the unit.
4
Press REC on the unit to start recording.
When all loaded discs are recorded, recording will stop.
You cannot exchange a disc while recording another disc.
Pressing CD REC MODE changes the disc playback mode to
Continuous Play and cancels the Repeat Play mode.
All Discs Synchronized Recording
1
Insert a recordable cassette into the cassette
compartment with the exposed part of the
tape facing left.
2
Load discs into the 5-CD Changer.
• You can make a program (see page 17) or select the
Random Play mode (see page 18) if you want. In this
case, you cannot select the starting disc
= go to step
5
.
3
Press one of the disc number
buttons (CD 1 – CD 5) on the
remote control to select the disc
you want to start recording from,
then press 7.
4
Press CD REC MODE on the remote
control to select “ALL CD.”
Each time you press the button, The recording
mode changes as follows:
5
Press REC.
The
indicator lights up on the display and
recording starts.
When all loaded discs are recorded, recording will stop. Both
the 5-CD changer and the cassette deck stop automatically.
Elapsed playing timeCurrent track number
21_24FS_B70[C].p65 03.3.19, 10:50 AM23
To Next Page
Loading...
