EN
71
CONTINUED ON NEXT PAGE
• The light used to illuminate the LCD
monitor causes it to become hot.
• This may occur when the surface or
the edge of the LCD monitor is
pressed.
• Certain Fade/Wipe effects, certain
modes of Program AE with special
effects, “DIS” and other functions
that cannot be used together are
selected at the same time.
• The LCD monitor and the view-
finder are made with high-precision
technology. However, black spots or
bright spots of light (red, green or
blue) may appear constantly on the
LCD monitor or the viewfinder.
These spots are not recorded on
the tape. This is not due to any
defect of the unit. (Effective dots:
more than 99.99 %)
• This is normal.
• The Power Switch is set to “
”
or “
MANUAL
”.
• The VIDEO/MEMORY Switch is set
to “VIDEO”.
• Close the LCD monitor to turn it off
or set the Power Switch to “OFF”,
and let the unit cool down.
————
• Re-read the sections covering
Fade/Wipe effects, Program AE
with special effects and “DIS”
(
墌 pg. 36 – 39, 45).
————
————
• Set the Power Switch to “PLAY”
(
墌 pg. 21).
• Set the Power Switch to “PLAY”
(
墌 pg. 28).
• Set the VIDEO/MEMORY
Switch to “MEMORY”.
SYMPTOM POSSIBLE CAUSES CORRECTIVE ACTION
w The rear of the LCD monitor
is hot.
e The indicators and the
image color on the LCD
monitor are not clear.
r The LCD monitor or
viewfinder indications blink.
t Colored bright spots appear
all over the LCD monitor or
the viewfinder.
y During recording, sound
cannot be heard.
u Play, Rewind and Fast-
Forward functions do not
work.
i A memory card cannot be
played back.
To Next Page
Loading...
Need help?
General
