2-28 (No.86700)
2.2.5 SERVISE NOTE
Use the following chart to manage screws.
Fig.2-2-7
Symbol No. [1] [7] [13] [19] [21] [22] [23]
Removing order of screw12345678910111213141516171819
Place to stick screw
Reference drawing (Fig. No.) M1 M2 M3 M4 M5
Screw tightening torque
Symbol No. [24] [31]
Removing order of screw 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39
Place to stick screw
Reference drawing (Fig. No.) M6 M7
Screw tightening torque
<NOTE>
Pay careful attention to tightening torque for each screw.
Torque setting value of torque driver is limited. At the values over the maximum torque setting value, fasten a screw manually
not to damage the screw thread.
[10] [12] [20]
M8
[25] [26] [37]
To Next Page
Loading...
