2-38 (No.86700)
Note:
• When replacing the worm bearing of the loading motor
assembly, attach it according to the following specifi-
cation.
If worm bearing is not attached correctly, a mechanism
noise may occur. (See Fig. 2-3-18)
Fig.2-3-18
2.3.6.7 Capstan motor, load gear, control plate
2.3.6.7.1 Removal
(1) Detach the belt.
(2) Check that the FFC connector on the drum is disconnect-
ed.
(3) Release the catch (a) to remove the FFC wire.
(4) Remove the screws (a) to detach the capstan motor.
(5) Remove the screws (b) to detach the fixing plate.
(6) Release the catch (b) to detach the load gear.
(7) Turn the load gear (S/T) in the loading direction to detach it.
(8) Remove the control plate.
Fig.2-3-19
6.8 ± 0.2 mm
WORM BEARING
LOADING MOTOR
Catch (a)
Catch (b)
Screws (b)
CONTROL
PLATE
LOAD GEAR
FFC
Load gear (T) assembly
Load gear (S) assembly
LOAD GEAR
FIXING PLATE
Capstan motor assembly
BELT
Screws (a)
To Next Page
Loading...
