JVC GR-DX107EK - Page 88

(No.86700)2-13
2.1.5.11 [35] DRUM BASE ASSY
[36] CAPSTAN MOTOR
[37] MAIN DECK ASSY
NOTES 35a/36:
Since [36]CAPSTAN MOTOR is attached to [35]DRUM BASE
ASSY, remove [36]CAPSTAN MOTOR together with
[35]DRUM BASE ASSY when removing [36]CAPSTAN MO-
TOR.
[36]CAPSTAN MOTOR should not be separated from
[35]DRUM BASE ASSY except when replacing them.
NOTE 35b:
It is very important to attach [35]DRUM BASE ASSY to the
proper position.
Especially, improper engagement of [36]CAPSTAN MOTOR
with [34]REEL GEAR 1 causes operational defection or abnor-
mal sound. Therefore, confirm the attachment position before
disassembly procedure.
See the following figure as for the proper attachment position.
Fig.2-1-24
NG
OK
NG
NOTE 35b
When [35]DRUM BASE ASSY
is properly attached, the screw
hole tends to be located at the
center of the oval.
When the screw hole is
located far from the center of
the oval, operational defection
or abnormal sound may occur.
Before removing [35]DRUM
BASE ASSY, confirm the
position of [35]DRUM BASE
ASSY by seeing the length
(A), as shown in the left figure.
When reattaching [35]DRUM
BASE ASSY, confirm the
position to reattach [35]DRUM
BASE ASSY by seeing the
length (A). Be sure to reattach
[35]DRUM BASE ASSY to the
same position as it has been
before the removing proce-
dure.
(A)
(S35)
27
(S35)
28
(S36)
30
(S35)
29
[35]
[36]
[37]
NOTE 35b
NOTE 35a
NOTE 36
*
*
**
*
* 0.078 N
.
m (0.8 kgf
.
cm)
** 0.039 N
.
m (0.4 kgf
.
cm)