JVC GX-N7E User Manual

esi Shia Se acecne
_ and insert the power plug into the POWER jack at the same
i time.
" Notes:
_™ How to Install Viewfinder ©
.
First
align
the
key
(
24)
in
viewfinder
connector
@
‘with
the
groove
(
QZ)
)
in
the
viewfinder
socket,
and
then
~
For
easier
and
more
enjoyable
on-the-spot
shooting,
view:
—
HOW
TO
SET
UP
THE
CAMERA
MIC jack
(3.5 mm dia. stereo mini jack)
[1]
HOW
TO
INSTALL
THE
MICROPHONE
Mike plug
Insert
the
mike
plug
of
provided
mike
@
into
the
MIC
jack,
{3.5
mm
dia,
stereo
mini
plug}
® Confirm that provided mike @ is fully inserted.
©
The
power
jack
is
exclusively
for
use
with
provided
mike @; do not insert other plugs into it.
Power plug POWER jack
HOW
TO
INSTALL
THE
VIEWFINDER
THE
IMAGE ON
ITS
SCREEN
Plug connector @ into the socket.
Note:
Confirm
that
viewfinder
connector
@
is
fully
plugged into the socket.
Viewfinder socket
"©
How
to
Adjust
the
Position
of
Viewfinder
®
Parallel!
(standard)
position
*
finder
®
is
designed
to
Operate
in
three
different
positions
,
by
moving
and
rotating
it:
paraliel
(standard),
inclined
and
_
at
right-angles,
'@
To
move
viewfinder
®
to
the
inclined
position
from
the
parallel
position.
©
Lift
the
viewfinder
@
neck
in
the
direction
of
arrow
®
until
the
viewfinder
is
firmly
locked.
Note:
Push
the
screen
end
in
the
opposite
direction
of
arrow
@
to
put
it
back
to
the
parallel
position
from
the
inclined
position.
.©
To
move
viewfinder
@
to
the
right-angle
position
from
the
inclined
position.
i
@
Stide
the
viewfinder
®
guide
joint
in
the
direction
of
H
attow
®
and
remove
it
from
the
viewfinder
guide.
(Rotate
viewfinder
@®
in
the
direction
of
arrow
©.
and
press
it
on
the
rear
of
the
camera
until
it
is
firmly
locked.
Note:
In
order
to
move
viewfinder
@
from
the
Right-angle
position
right-angle
position
to
the
inclined
position,
pull
the
screen
end
in
the
opposite
direction
of
arrow
©
to
release
the
lock,
and
rotate
the
viewfinder
to
the
top
of
the
camera.
Finally,
insert
the
viewfinder’s
joint
into
the
guide
untit
the
viewfinder
is
firmly
locked.
Qe
Aue
{©
Operate
the
camara
with
viewfinder
§
firmly
locked
in
one
of
the
three
positions.
Never
leave
the
viewfinder
between
these
positions.
Viewfinder guide
1
~4E
,
ADJUST
ITS
POSITION
AND
ENLARGE
[3]HOW
TO
ADJUST
THE
GRIP
BAND
* @ Detach the end of grip band @® from the end fixed to
@With your right hand inside grip band ®, pull the
Loék button
@ HOW TO MAGNIFY THE IMAGE ON THE VIEW-
FINDER’S SCREEN
Slide the viewfinder @ outer case in the direction of the
arrow until it clicks into its locked position to magnify the
image on the viewfinder’s screen. in B
Note: To bring the outer case back to the origina! position, Notch
press the lock button in and slide the case in the
opposite direction of the arrow until the case stops 5. e
at its original position. Outer Outer:
case case
Lock button Lock button
: the camera, and loosen the band.
end: to the left to tighten it, and then press the Velcro
Pieces together.
Notes:
®@ Confirm that the Velcro pieces are together firmly.
@ Looping the lens cap @ string around the grip band
® facilitates uncapping and capping the lens.
[4] HOW TO INSTALL THE CAMERA CABLE
iO) Align the key (24) on the camera connector of provided Proper connection
camera cable @ with the groove (01) in the camera
cable socket @
@® Insert the connector into the socket @.
Note: Never attempt to force the 10-pin rectangular
camera connector of provided camera cable @ into
the camera cable socket when the connector is posi-
tioned upside down.
Improper connection
@ When removing the camera connector, remove by
gripping the camera connector, not the cable.
— 5E —
Outer case
@Set the outer case to the A
or B position for the best
viewability,
A position:
Pull the outer case in the
direction of the arrow as far as
it goes,
5 position:
Hold the lock button in, and
Puli the outer case back
slightly, into the notch of the
button,
Camera connector
(10-pin rectangular)

JVC GX-N7E Specifications

General

Brand	JVC
Model	GX-N7E
Category	Camcorder
Language	English