JVC GX-N7E

3. To disassemble EVF hood, remove the eye cap in the [— J
direction of the arrow as shown in Fig. 12-3. REMOVING THE EVF, BOARD AND CRT
4.
Press
the
clip
securing
the
lens
in
the
direction
of
the
1.
Remove
the
two
screws
(@)
shown
in
Fig.
13-1.
:
arrow
and
remove
fens,
as
shown
in
Fig,
12-4.
2.
Remove
the
EVF
cover
by
lifting
in
the
direction
of
5. Pull the lock plate in the direction of the arrow the arrow as shown in Fig. 13-2. .
shown
in
Fig.
12.5,
3.
Removing
the
CRT
socket
and
connector
shown
He
1
NOTE: When locking the EVF hood becomes impos- Fig. 13-3 will allow the circuit Beardie ye pe pee
sible
while
shooting
under
special
atmospheric
oN
4.
Removing
the
two
®)
screws
shown
in
a
“
conditions
(high
temperature/humidity),
use
allow
disassembly
of
the
CRT
and
DY
assembly.
the EVF by slightly bending the tock plate.
Eye cup
i
Screw
@)
Fig.
12-3
Disassembling
the
EVF
(3)
|
Fig.
13-1
Removing
the
EVF
board
and
CRT
(1)
EVF BOARD
Lens
Fig. 12-4 Disassembling the EVF (4)
"Lock plate
Fig. 12-5 Disassembling the EVF (5)
LED light guide
Screw ®
Pate
Fig.
13-4
Removing
the
EVF
board
and
CRT
(4)
(No. 5550) 15E !
16E (No. 5550)