JVC GX-N7E

=m DISASSEMBLY & REPLACEMENT OF BIAS
LIGHT & OPTICAL LOW-PASS FILTER
1. Remove the connector shown in Fig. 9-1.
2. Fig. 9-2 shows disassembly method.
NOTE: When replacing the BIAS tight board and LPF,
be sure to confirm which sides are back and
front and which are top and bottom.
a REMOVING THE GRIP BELT
1. Remove the two screws (a) shown in Fig. 10.
Connector
LPF & BIAS LIGHT
Fig. 9-1 Disassembly & replacement of bias light & optical
low-pass filter
~ thee = cath —————
length
—~t—_ TUBE {
>. at
—P
LENS
AWN
Bias light board
Fig. 9-2 Disassembly & replacement of bias light & optical
low-pass filter
Screw (a)
Body cover
Fig. 10 Removing the grip belt
{No. 5550) 13E
= REMOVING THE VTR SWITCH
1.
Remove
the
two
screws
“a)
shown
in
Fig.
11-1
and
detach.the
VCR(VTR)
SW
board.
|
2.
As
shown
in
Fig.
11-2,
remove
the
knob
stoppers
in
the
direction
of
the
arrow,
then
remove
the
VCR
(VTR)
START/STOP
knob.
_| = DISASSEMBLING THE ELECTRONIC VIEW.
FINDER (EVF)
shaft and detach the EVF arm.
1
pull
the
EVF
hood
in
the
direction
of
the
arrow.
| be adjusted while EVF hood is removed.
14€ (No. 5850)
|
|
1. Remove the & ring shown in Fig. 12-1, pull out the
1°
2.
While
pressing
the
button
(A)
shown
in
Fig.
12-2,
NOTE: FOCUS, BRIGHT, V. HIGHT and H. HOLD can
VCRIVTR) SW BOARD
Screw “a)
|
Beoal
Fig. 11-1 Removing the VCR (VTR) switch (1)
®
E ring
Fig.
12-1
Disassembling
the
EVF
(1)
'
EVF hood
Y
Fig. 12-2 Disassembling the EVF (2)