JVC GY-X1TC - Full-time auto white balance on;off

@ Full-time auto white balance on/off
Parameter name Data
3.FULLTIME AW ON - OFF
This parameter determines whether the full-time auto white
balance mode is engaged or not when the W. BAL switch is
set to AUTO 2.
ON: Full-time auto white balance in the AUTO 2 position.
OFF: Normal auto white balance.
@ Audio level indicator on/off
Parameter name Data
4.AUDIO IND ON - OFF
This parameter determines whether the audio level indicator
is to be displayed or not on the Mode-0 status display
screen.
ON: _ Indicator on.
OFF: No indication.
e Audible warning messages on/off
Parameter name Data
The audible warning messages can be defeated by this
parameter.
ON: Messages on.
OFF: Messages off.
e VIR start/stop trigger mode
Parameter name Data
6.VTR SW N-LOCK ING
LOCKING
Set this parameter according to the type of the VTR
start/stop trigger on the lens.
N-LOCKING: Set this data for lenses with a
momentary-type trigger (which stays ON
only while it is being pressed, and is OFF
when released.)
Applicable lense: HZ-714
LOCKING: Set this data for lenses with an
alternating-type trigger (which goes ON
when pressed, and OFF when pressed
again.)
Applicable lense: HZ-713
Important note:
@ When using the HZ-713, an optional connector
conversion adapter is necessary.
@ Mode-1 status display setting
Parameter name Data
BATT -GAIN-FILTER
7. STATUS! BATT -GAIN-FI
The item to be displayed on the Mode-1 status display
screen can be selected.
BATT : Battey voltage
GAIN : Camera sensitivity
FILTER _ : Filter position
SHUT : Shutter speed
WB MODE : White balance mode
e AUTO switch function setting
Parameter name Data
8.AUTO
SET
NORM
-AB
This parameter determines the operation of the AUTO switch
when it is pushed toward SETUP/BLK.
NORM: Automatic adjustment of black balance, white
balance and black balance in succession.
AB: Automatic adjustment of black balance only.
e Quick recording special mode on/off
Parameter name Data
ae eo
1: Normal mode
2: Special mode (see page 26)
© Battery warning voltage setting
Parameter name Data
10. BATT END 11,.0V 00 12.0V
The voltage at which the battery warning starts operating.
lf the power is switched off during memory setting operations, the data being set will not be stored in the memory.
This
means
all
parameters
will
require
re-setting.
Be
sure
to
return
to
the
camera
signal
screen
before
switching
off
the
power.