Menus Settings: [ ] = Factory-preset
>
ZEBRA
The over-exposed sections of
the subject are displayed in
striped pattern on the screen.
Use this as a guide for adjusting
the brightness.
(In ! mode only)
1 [OFF]: Deactivates the function.
70%: Sections that are close to be over-exposed are
displayed in striped pattern.
100%: Sections that are over-exposed are displayed in
striped pattern.
NOTE
Correct the brightness by using the shutter speed or aperture
priority setting function.
^
SHARPNESS
Enhances the outline of the
subject.
(In ! mode only)
Adjust the sharpness using the touch sensor, then touch OK.
NOTE
Enhancing the sharpness causes the recorded image to appear
grainy.
To Next Page
Loading...
