Date/Time Setting
Q
Open the LCD monitor to
turn on the camcorder
R
Select [YES] within
10 seconds
•
When the message disappears, press the
power button for at least 2 seconds to turn
off the power, and then press it again for at
least 2 seconds.
•
Touch the sensors with your finger. The
sensors do not function if you touch them
with your finger nail or with gloves on.
S
Select [CLOCK SETTING]
T
Select the city closest to
the area where you use
the camcorder
U
Select [ON] if daylight
saving time is observed
V
Set the date and time
Slide your finger up and down on the
sensor. Then touch OK.
Touch sensor: Sets the date and time
&
: Moves the cursor to the right
OK: Clock starts
Power button
LCD monitor
To Next Page
Loading...
Need help?
General