e ec ulibn
Installation
• Install in a place which is level, dry and neither too hot nor
too cold--between 5°C and 35°C.
• Install the System in a location with adequate ventilatiou to
prevent internal heat buildup in tire System.
• Leave sufficient distance between the System and the TV.
• Keep the speakers away from the TV to avoid interference
with TV.
Powersources
• When unplugging the System from the wall outlet, always
pull on the plug, not the AC power cord.
Moisture condensation
Moisture nmy condense on tire lenses irrside the System in
fl`1etbllowing cases:
• After starting to heat the room
• In a damp r00n'!
• If the System is brought directly from a cold to a warm
place.
Should this occur, the System nmy nmlflmction. In this case,
leave the System turned on for a few hours until the moisture
evaporates, unplug the AC power cord, then plug it in again.
Internal heat
• A cooling fan is mounted on the rear panel to prevent heat
buildup inside the unit.
For safety, observe the foUowing carefuUy:
• Make sure there is good ventilation around
the unit. Poor ventilation could overheat
Others
• Should any metallic object or liquid fall into tile System,
unplug the AC power cord and consult your dealer before
operating any further.
ii A DO NOT disassemble the System since
$r._l there are no user serviceable parts inside.
• If you are not going to operate tile System for an extended
period of time, unplug the AC power cord from the wall
outlet.
If arrything goes wrong, unplug the AC power cord arrd
consult your dealer.
:ioRe fl Ibis: Nahuai :
To make the exphmations in this nmnual assimple and easy-
to-understand as possible, we have adapted the following
methods:
• Button and control operations are explained as listed in the
table below.
• Some related tips and notes are explained later in the
sections "Learning More about This System" and
"Troubleshooting," but not in the same section
explaining the operations. If you want to know more about
the fimctions, or if you have a doubt about the functions, go
to these sections and you will find the answers.
Indicates that you press tire button
briefly.
Indicates that you press tire button
briefly and repeatedly until an
option you want is selected,
Indicates that you press one of fl`1e
buttons.
Indicate that you press and hold d`1e
button for an specified periods.
• The number inside the arrow
irrdicates the period of press (in dfis
example, 2 seconds).
• If no nmnber is inside the arrow,
press arrd hold until the entire
procedure is complete or until you
get a result you want.
Indicate that you turn fl`1econtrol
_ toward the specified direction(s).
Indicates that this operation is only
possible using tire remote control.
Indicates that this operation is only
possible using tire buttons arrd controls on
tire main unit,