Before operating the unit — Cancel the display demonstration and set the clock
• See also page 29.
~ Turn on the power.
Ÿ Enter the PSM settings.
! ] ⁄ Cancel the display demonstrations
Select “DEMO,” then “DEMO OFF.”
Set the clock
Select “CLOCK H” (hour), then adjust the hour.
Select “CLOCK M” (minute), then adjust the minute.
Select “24H/12H,” then “24H” (hour) or “12H” (hour).
@ Finish the procedure.
ENGLISH
5
When the power is turned off: Check the current clock time
When the power is turned on: Change the display information
How to detach/attach the control panel
Detaching... Attaching...
CAUTION:
The lever comes out if you pressed the 0 button while the
panel is detached. If this happens, push the lever back into lock
position before attaching the panel.
Lever
EN02-05_DV6202_001A_3.indd 5EN02-05_DV6202_001A_3.indd 5 12/19/05 2:46:10 PM12/19/05 2:46:10 PM
To Next Page
Loading...
