19
ENGLISH
Adjusting the sound
You can adjust the sound characteristics to your
preference.
1
*
1
Displayed only when “L/O MODE” is
set to “WOOFER” (see page 21).
Ex.: When “TRE” is selected
2
Indication pattern changes as
you adjust the level.
Indication To do: Range
BAS*
2
(bass)
Adjust the bass. –06 (min.)
to
+06 (max.)
TRE*
2
(treble)
Adjust the treble. –06 (min.)
to
+06 (max.)
FAD*
3,
*
7
(fader)
Adjust the front
and rear speaker
balance.
R06 (Rear
only)
to
F06 (Front
only)
BAL*
7
(balance)
Adjust the left
and right speaker
balance.
L06 (Left
only)
to
R06 (Right
only)
LOUD*
2
(loudness)
Boost low and
high frequencies
to produce a well-
balanced sound at
low volume level.
LOUD ON
J
LOUD
OFF
SUB. W*
4
(subwoofer)
Adjust the
subwoofer output
level.
00 (min.)
to
08 (max.)
VOL*
5
(volume)
Adjust the
volume.
00 (min.)
to
30 or 50
(max.)*
6
*
2
When you adjust the bass, treble, or
loudness, the adjustment you have made is
stored for the currently selected sound mode
(C-EQ) including “USER.”
*
3
If you are using a two-speaker system, set
the fader level to “00.”
*
4
This takes effect only when a subwoofer is
connected.
*
5
Normally the control dial works as the
volume control. So you do not have to select
“VOL” to adjust the volume level.
*
6
Depending on the amplifier gain control
setting. (See page 22 for details.)
*
7
This adjustment cannot affect the subwoofer
output.
EN18-23_KD-S51[J]f.indd 19EN18-23_KD-S51[J]f.indd 19 11/3/04 9:58:08 AM11/3/04 9:58:08 AM
To Next Page
Loading...
