JVC KD-X320BTS User Manual

26
Symptom Remedy
SiriusXM® Radio
“CHLOCKED LOCK
CODE?”
The selected channel is locked. Enter the correct pass code
to unlock.
( 13)
“CHANUNSUB” The selected channel is unsubscribed.
Call 1-866-635-2349 in U.S.A. or 1-877-438-9677 in Canada
to subscribe.
“CHUNAVAIL” The selected channel is unavailable. Visit
www.siriusxm.com for more information about the
SiriusXM channel lineup.
“CHKANTENNA” Check the antenna and its connection are in good condition.
“CHECKTUNER” Make sure the SiriusXM Vehicle Tuner is connected to the
unit.
“NOSIGNAL” Make sure the antenna is mounted outside the vehicle.
“SUBSCRIPTION
UPDATED – PRESS
ENTER TO CONTINUE.”
Your subscription is updated. Press the volume knob to
continue.
“CODE ERROR” Make sure you have entered the correct pass code.
( 13)
“NO CONTENT” There is insufficient content to start TuneScan.
“SCAN CANCEL” TuneScan has been aborted.
Bluetooth®
No Bluetooth device is
detected.
• Search from the Bluetooth device again.
• Reset the unit.
( 3)
Pairing cannot be
made.
• Make sure you have entered the same PIN code to both the
unit and Bluetooth device.
• Delete pairing information from both the unit and the
Bluetooth device, then perform pairing again.
( 14)
Echo or noise occurs. • Adjust the microphone unit’s position. ( 14)
• Check the [ECHO CANCEL] setting. ( 15)
Phone sound quality
is poor.
• Reduce the distance between the unit and the Bluetooth
device.
• Move the car to a place where you can get a better signal
reception.
TROUBLESHOOTING
Symptom Remedy
Bluetooth®
Sound is being
interrupted or skipped
during playback of a
Bluetooth audio player.
• Reduce the distance between the unit and the Bluetooth
audio player.
• Turn off, then turn on the unit and try to connect again.
• Other Bluetooth devices might be trying to connect to the
unit.
The connected
Bluetooth audio player
cannot be controlled.
• Check whether the connected Bluetooth audio player
supports Audio/Video Remote Control Profile (AVRCP).
(Refer to the instructions of your audio player.)
• Disconnect and connect the Bluetooth player again.
“PAIRING FULL” The number of registered devices has reached its limit.
Retry after deleting an unnecessary device.
( 18,
DELETE PAIR)
“PLEASE WAIT” The unit is preparing to use the Bluetooth function. If the
message does not disappear, turn off and turn on the
unit, then connect the device again.
“BT DEVICE NOT FOUND” The unit failed to search for the registered Bluetooth
devices during
[AUTO CNNCT] . Turn on Bluetooth from
your device and connect manually.
( 18)
“NOT SUPPORT” The connected phone does not support Voice Recognition
feature.
“ERROR” Try the operation again. If “ERROR” appears again, check
if the device supports the function you have tried.
“H/W ERROR”
Reset the unit and try the operation again. If “H/W
ERROR” appears again, consult your nearest service center.
“BT ERROR PLS UPDATE” Update the Bluetooth firmware. ( 4)
If you have any troubles, try the following:
1 Check TROUBLESHOOTING
2 Reset the unit (
3)
3 Contact (USA only)
Call: 1-800-252-5722 ( or ) visit: http://www.jvc.com
JS_JVC_KD_X320BTS_J_EN_2.indd 26 11/9/2014 4:58:01 PM

JVC KD-X320BTS Specifications

General

Brand	JVC
Model	KD-X320BTS
Category	Receiver
Language	English