JVC MX-J570V - Connecting Other Equipment and Voltage Selection

MX-J570V/MX-J680V
1-13
Prior to performing the following procedure, remove
the metal cover and CD changer mechanism
assembly.
Remove the two plastic rivets attaching the joint
board, and remove the joint board.
Disconnect the card wire from connector CN1 on the
tuner board.
Remove the two screws Y attaching the tuner board
on the back of the body.
1.
2.
3.
Removing the tuner board
(See Fig.21 and 22)
<Rear panel assembly>
Prior to performing the following procedure, remove
the metal cover and CD changer mechanism
assembly.
Remove the two plastic rivets attaching the joint
board, and remove the joint board.
Disconnect the card wire from connector CN315 on
the input / output board.
Disconnect the harness from connector CN912 on
the input / output board.
Remove the screw Z attaching the input / output
board on the lower side of the body.
Disconnect connector CN612, CN870, CN871,
CN711 and CN712 on the input / output board and
pulling out them outward. Remove the input / output
board from the body.
1.
2.
3.
4.
5.
Removing the input / output board
(See Fig.21 and 22)
Fig.21
Fig.22
Tuner board
Plastic rivets
Joint board
Input / output board
Rear panel
CN1
CN871
CN870
Z
CN711
CN712
CN315
Rear panel
Y
E
G
CN912
CN612