JVC TS-CL110U User Manual

- 1 -
English
LAMP REPLACEMENT INSTRUCTIONS
Replacement Lamp Kit
TS-CL110U
Warning:
This Lamp Kit is only for use with JVC television models.
LCT1688-001E-A
1005TNH-II-IM
WARNING
Hg
For USA only
Hg-LAMP CONTAINS MERCURY! Manage in accord with disposal laws.
Go to: www.lamprecycle.org or call 1-800-252-5722.
NOTICE (for USA)
This product has a High Intensity Discharge (HID) lamp that contains a small amount
of mercury. It also contains lead in some components. Disposal of these materials
may be regulated in your community due to environmental considerations. For
disposal or recycling information, please contact your local authorities, or the
Electronics Industries Alliance: http://www.eiae.org
The following instructions will tell you how to safely replace the projection lamp. Please read
these instructions carefully before attempting to replace the lamp. If you feel unsure about
replacing the lamp, call a service technician.
It is important that you NEVER TOUCH THE GLASS SURFACE OF THE NEW LAMP.
Touching the glass surface of the lamp will deposit oils from your hands onto the glass
surface. When the lamp heats up to its operating temperature, the oil will cause a difference in
temperature on the glass surface that will likely cause the lamp to break.
This lamp is for use ONLY with JVC model televisions. Using the lamp with a different
television or other product could cause a malfunction and/or damage to the television or lamp.
Under normal operating conditions, THE LAMP WILL GET EXTREMELY HOT AND WILL
CAUSE SEVERE BURNS IF TOUCHED. Before attempting to replace the lamp perform the
following:
1) Make sure the television has completely run through its cooling cycle.
2) Turn off the power and wait until the LAMP LED blinks very slowly and turns off completely.
3) Unplug the TV.
If you feel any warmth as you place your hand near the lamp, DO NOT TOUCH IT. Wait until
the lamp has completely cooled down before attempting to replace it.
NEVER: Attempt to replace the lamp while the TV is plugged into the wall outlet. Attempting
to replace the lamp with the TV plugged in could lead to a severe electrical shock or
death.
LCT1688-001E.indd 1LCT1688-001E.indd 1 11/1/05 9:56:29 AM11/1/05 9:56:29 AM

JVC TS-CL110U Specifications

General

Brand	JVC
Model	TS-CL110U
Category	Outdoor Light
Language	English

Summary

Important Safety Precautions

Mercury and Disposal Warning

Information on mercury content in the lamp and proper disposal laws for the USA.

Lamp Handling and Heat Safety

Crucial warnings about not touching the lamp surface due to oils and extreme heat causing burns.

Electrical Shock Hazard

Warning against replacing the lamp while the TV is plugged in to prevent severe electrical shock or death.

Lamp Replacement Procedure

Preparation Steps

Turn off, unplug the television, and allow cooling before starting replacement.

Accessing the Lamp

Steps to remove screws and speaker panels to access the lamp cover.

Lamp Unit Removal and Installation

Instructions on how to remove the old lamp unit and install the new one securely.

Reassembly and Final Steps

Re-installing covers, panels, screws, and resetting the lamp timer.

Troubleshooting Warning LEDs

LAMP LED Blinking

Indicates potential internal electrical circuit malfunction; suggests power cycling.

POWER and LAMP LEDs Alternating

Suggests abnormal internal temperature or blocked fan; advises power cycling and consulting dealer.

POWER and LAMP LEDs Simultaneous Blinking

Indicates improper lamp installation or malfunction; recommends reinstallation or service.

Limited Warranty Information

Warranty Coverage and Period

Details parts and labor coverage for 90 days within the United States.

Customer Service and Exclusions

Instructions for obtaining service and a list of items not covered by the warranty.