JVC UX-C7

UX-C7 B/E/G/GI/EN
Presetting stations
(using the remote control unit)
15 stations in each band (FM and AM (MW/LW)) can be
preset as follows:
@ Example (when presetting an FM station broadcasting at
103.5 MHz to preset button "15")
@ Press the TUNER/BAND button.
@ Select the FM band using the TUNER/BAND button.
@ Tune to the required station.
© Press preset button "+10", then "5" for more than 2 sec.
(When "15" blinks in the preset station display, the
station has been preset.)
® Repeat the above procedure for each of the other
stations, using a different preset button each time..
© Repeat the above procedure for the AM (MW/LW) band.
® To change preset stations
Perform step @ above after tuning to the required
station.
Preset tuning
e
The
stations
must
be
preset
before
this
operation
can
be
performed.
(Using
the
controls
of
the
main
unit)
@ Press the TUNER/BAND button.
@
Select
the
band
(FM
or
AM
(MW/LW))
using
the
TUNER/BAND
button.
@
Press
the
PRESET
TUNING
button
to
select
the
required
preset
station.
(using
the
remote
control
unit)
@ Press the TUNER/BAND button
@
Select
the
band
(FM
or
AM
(MW/LW))
using
the
TUNER/BAND button.
®
Press
the
required
preset
station
buttons
(No.1
~
No.10,
+10).
;
©
The
preset
station
number
and
frequency
corresponding
to the button pressed are shown.
Using the antennas
FM: Connect the provided FM feeder antenna
(see page 7).
AM (MWILW) :
Adjust
the
position
of
AM
(MW/LW)
loop
antenna.
18 (No. 1898)
Notes: ~
© The previous preset station is erased when a new
station is set as the new station's frequency replaces
the previous frequency in memory.
@ When listening to an AM (MW/LW) broadcast, noise may
be heard if the remote control is used.
© All preset stations will be erased when the power cord is
disconnected or a power failure occurs for more than 24
hours. In such cases, preset them again.
RECORDING (coxa) é
® In recording, the ALC circuit automatically optimizes the
recording level; adjustment of the recording fevel is
unnecessary.
® Check that the safety tab on the cassette tape is not
broken off.
Notes:
This unit has recording characteristics suitable for normal
and CrOz tapes. Normal and CrO , tapes have different
characteristics from metal tape.
DOLBY NR SYSTEM
e Set the DOLBY NR as required. The DOLBY NR
indicator lights.
Note:
The optimum sound quality will not be obtained if different
DOLBY NR switch settings are used during recording and
playback.
It should be noted that it may be unlawful to re-record
pre-recorded tapes, records, or discs without the
consent of the owner of copyright in the sound or video
recording, broadcast or cable programme and in any
literary, dramatic, musical, or artistic work embodied
therein.