JVC UX-C7

Erasing
When
recording
on
a
pre-recorded
tape,
the
previous
recording
is
automatically
erased
and
only
the
new
material
can
be
heard
when
the
tape
is
played.
:
To
erase
a
tape
without
making
a
new
recording...
Press
the
m@
(stop)
button
to
set
to
the
TAPE
mode,
then
perform recording.
Synchronized recording with the CD player
@ In this system, the CD player starts playback when the
cassette deck enters the recording mode.
Operate In the order shown
(Recording from the CD changer)
i
AUTO REVERSE
© Press the DISC CONTROL button corresponding to the
disc to be recorded.
@ Press the m/CLEAR button to set stop mode.
© Load a cassette with side A facing out. (Wind past the
leader tape before starting recording.)
@ When programmed playback is required, program the
required tunes using the remote control. (See page
26.)
® Select tunes with a total playing time which does not
exceed the tape length.
© Select the required reverse mode( = or FD )
© Press the SYNCHRO REC button; synchronized
recording will start.
@ Recording starts in the forward direction and CD play
starts automatically.
e@ When the CD player has played the disc or programmed
tunes, the deck stops automatically.
e Non-recorded sections of approx. 4 seconds are
automatically left between tunes.
4 UX-C7 B/E/G/GI/EN
CD complete recording function (Synchro recording
mode only)
lf the tape is reversed while a CD is being played, recording
will be done on the reverse side of the tape as follows:
* When less than 12 seconds of the last tune on the
forward side of the tape have been recorded, recording
on the other side of the tape will start from the beginning
of the previous tune.
* When more than 12 seconds of the last tune on the
forward side of the tape have been recorded, recording
on the other side of the tape will start from the beginning
of the current tune.
To record an entire disc in the tune order of the CD
After the operations in steps @ - @ above, press the >/!
button of the CD player after the @/1l and > buttons have
been pressed.
Note:
® During synchro recording, the PAUSE and SEARCH
buttons do not function.
e To stop recording, press the M/CLEAR button of the CD
player. (If the mf (stop) button of the cassette deck is
pressed, the program will be cleared during programmed
playback.)
(Recording from the EXTRA-CD)
Load the EXTRA-CD and press the m/CLEAR button to set
stop mode, and press the SYNCHRO REC button.
When automatic spacing between tunes is not
required ...
Perform the following.
1. Press the [>/H button of the CD player twice. The CD
Player enters the pause mode.
2. Press the SYNCHRO REC button to start recording.
Notes:
© Depending on the disc used, blanks of a specified
length may be left between tunes.
@ When synchro recording is performed using more than
two discs, non-recorded sections of approx. 4 seconds
are automatically left on the tape when changing the
disc.
(No. 1898)
19