CAUTION:
Do not allow your detector to be exposed to excessive heat by
leaving it in direct sunlight or inside of a closed vehicle on a
hot day. Excessive heat can damage the electronics and/or
destroy the detector’s waterproof seals.
NOTE:
If you purchased the optional “underwater connector on coil
wire”, before submerging the detector be sure the O-ring is in
the male half of the connector (the side mounted to the hous-
ing) and the female half of the connector is securely tightened.
When properly tightened, a small detent can be felt at the end
of the tightening.
When the coil wire is wrapped around the handle shaft no
strain should be placed on the wire where it attaches to the
connector. Sufficient slack should be left in the wire to create
relief at the connector. If the wire is wrapped tight it will pull
on the connector causing a leak into the connector.
Tape wire to shaft
if needed
Do not allow wire
to pull on connector
Correct setup. Wire does not pull
down on connector
Bad setup, connector may leak.
Wire pulls down on connector
Connector
To Next Page
Loading...
Need help?
General