3
•
minimum.
•
• Key rigging components must be inspected before each use.
• Any rigging components found to be defective, or even suspect might be
• Always use properly rated rigging hardware.
•
manufactured by K-array.
• K-array loudspeaker and hardware are intended for suspension from approved
of the suspension points.
•
and experienced professionals.
•
loudspeaker systems conform to all applicable laws and regulations in force at
the time and location.
•
•
system to ground in order to avoid any damage or failure due to any unintended
hits, gust of wind, vibrations or such.
• K-array cannot be held responsible for damage caused by improper use of the
loudspeakers.
•
limits are designed to provide reasonable protection against harmful
instructions, may cause harmful interference to radio communications. However,
to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
2.
3.
the receiver is connected.
4.
All trademarks are the property of their respective owners.
To Next Page
Loading...