Take a firm hold on the hand-wheel and the
handle and pull out Retractor with sensor inside.
Warning! A firm hold of the tool is essential as the
combination of the tool and the sensor is
noticeably heavier than Retractor alone.
Note: To ensure Isolation valve after the SAFE-
DRIVE tool with the sensor has been removed,
you can bolt a standard ANSI 1.5” 105 lbs blind
flange to Isolation valve with ½” (M12) bolts and
nuts.
A lock can be added to Isolation valve handle.
Warning! The sensor tip is hot and may be
covered with liquor. It is recommended to rinse
the sensor tip and Isolation valve with hot water.
Sensor removal
To Next Page
Loading...
