PAS 100 Operating Manual Page
10 of 31 Rev. 070807
Troubleshooting
Issue
IssueIssue
Issue
Possible Causes
Possible CausesPossible Causes
Possible Causes
Battery Not Charging
(no blinking bar graph)
Power cable not plugged in or no power at outlet. (The red AC light indicates
when the unit is plugged into a hot power outlet.)
No Sound Power switch not turned on. Input level knob turned down. Master Volume
turned down. Battery dead and not plugged into AC power.
Distorted Sound When red Input Overload light is flashing turn down the Input level knob.
Doesn’t Sound Good Check to be sure the Tone Control knobs for Bass, Mid and Treble are set to
their center (detent) position.
AC Light Not Glowing Red Power cable not plugged in or no power at outlet. Check the fuse in the
speaker next to the AC cord plug.
Compatible Accessories
PC 100
PC 100PC 100
PC 100
Durable heavy duty cover designed to protect the PAS during transport and
operation.
LRR 100
LRR 100LRR 100
LRR 100
Wire frame luggage trolley suitable for transporting the PAS 100.
CDP3
CDP3CDP3
CDP3
CD player capable of MP3 disks designed for mounting in the PAS 100 option
slots.
Sennheiser Evolution
Sennheiser EvolutionSennheiser Evolution
Sennheiser Evolution
Wireless microphone receiver series offering flexible frequency selection and
superior performance designed for mounting in the PAS 100 option slots.
CE Declaration of Conformity
This equipment is in compliance with the essential requirements and other relevant provisions of
Directives 89/336/EC and 73/23/EC. The declaration is available on the internet site at www.klein-
hummel.com. Before putting the device into operation, please observe the respective country-
specific regulations!
To Next Page
