10
The “lock” condition is part of the security/safety feature of this heater
and it is to ensure, that user will physically check the thermostat unit
and verify the unit is in optimal operating condition before turning the
Heater back on.
4) HIGH LIMIT RESET
A high limit manual reset thermostat is provided as a secondary
back up high temperature limit protection. The reset thermostat
may trip if the pump is switched off meaning no water ow to
heater.
a. to reset, switch the heater breaker off. Allow the heater to cool
and then depress the high limit (as shown in Figure 04).
1)
FIGURE 04. HIGH LIMIT RESET THERMOSTAT (LOCATED UNDERNEATH).
3
SHOWING BY PASS
FIGURE 02.
The Heater shall be installed as per Figure 02.The water inlet and
outlets are connected to straight pipe connectors of the heater.
i. Do not store chlorine near or in the same room as heater.
ii. Valves must not be installed in the piping on the outlet of heater to
the pool/spa.
iii. Use Te on Tape for connecting leakage current collectors into tank
body and use Te on tape as sealer in the threads for drain plug.
The water fl ow in GPM should not exceed the following limits:
Caution:
1b)
To Next Page
Loading...