OWN-003 Model BDI Owner’s Manual – Blender Dispenser with Ice
11
5.4.4.2 Place an empty blender jar in the blend station.
5.4.4.3 Empty each product line by pressing the number of the pump (1-8)
and then holding the juice button down. This will remove the bulk
of the remaining product from the machine. Be sure that the
blender jar does not overflow.
5.4.4.3 Disconnect all product bag connectors from the product lines. You
will want to have a bucket or empty blender jar to capture any
product that leaks back out of the tubes.
5.4.4.4 Mix up a solution of hot soapy water.
5.4.4.5 Place the ends of the product tubes into the soapy solution.
5.4.4.6 To clean the tubes, run the soapy solution by pressing 9-8-0-GO.
This cycle will clean 2 pumps at a time. The beginning screen will
read “CLEAN 1 2 READY”. Press GO to activate the cycle.
Pumps 1 and 2 will run approximately 12 seconds each dispensing
the soapy water into the empty blender jar. Ensure that the jar does
not overfill!
5.4.4.7 Once the cycle is done, the screen will read “CLEAN 3 4
READY”. Make sure the blender jar is empty and press GO.
Pumps 3 and 4 will run. Repeat for all 8 pumps.
5.4.4.8 Place the product bag connectors in the sink to soak in a sanitizing
solution.
5.4.4.9 Retrieve a container (bucket) of clear rinse water.
5.4.4.10 Place all eight ends of the product tubes into the bucket of
water.
5.4.4.11 To run the sanitizing cycle to rinse – press 9-8-0-GO. This cycle
will rinse 2 pumps at a time. The beginning screen will read
“CLEAN 1 2 READY”. Press GO to activate the cycle. Pumps
1 and 2 will run approximately 12 seconds each dispensing the
rinse water into the empty blender jar. Ensure that the jar does
not overfill!
5.4.4.12 Once the cycle is done, the screen will read “CLEAN 3 4
READY”. Make sure the blender jar is empty and press GO.
Pumps 3 and 4 will run.
5.4.4.13 Repeat to clear the remaining pumps.
5.4.4.14 Place the ends of the product tubes into a bucket of clean rinse
water and repeat steps to rinse tubes.
5.4.4.15 Once the tubes have been rinsed, rinse and re-connect the product
bag connectors.
5.4.4.16 Mix up a solution of sanitizer per manufacturer’s instructions.
5.4.4.17 Place all eight tubes, with connectors attached, into the sanitizer
solution.
5.4.4.18 To run the sanitizing cycle to rinse – press 9-8-0-GO. This cycle
will sanitize 2 pumps at a time. The beginning screen will read
“CLEAN
1 2 READY”. Press GO to activate the cycle. Pumps
1 and 2 will run approximately 12 seconds each dispensing the
sanitizer into the empty blender jar. Ensure that the jar does not
overfill!
To Next Page
Loading...