7.1.4 Select the concentration ratio for the product you use in pump port 1 from
the table below. The pumps deliver about 1 oz. per second. Divide your
recipe’s product amount (the ounces required for a small drink) by 1.0 to
get the suggested pump time. E.g. If you use 2 to 1 product, divide 4 oz.
by 1.0 oz per second. 4/1 = 4.0 seconds. With the display showing
“Drink 1 Pmp 1 0” enter the suggested run time, remembering that what
you enter is in tenths of a second. E.g. Enter “40” to get 4.0 seconds, then
press GO.
Suggested Drink Formulae
Concentration
Ratio
Small
12 oz. Drink
Medium
18 oz. Drink
1
Large
24 oz. Drink
2
1.4 to 1
Pmp 6 oz.
Water 0 oz.
Ice 12 oz.
Pmp 9 oz.
Water 0 oz.
Ice 18 oz.
Pmp 12 oz.
Water 0 oz.
Ice 24 oz.
2 to 1
Pmp 4 oz.
Water 2 oz.
Ice 12 oz.
Pmp 6 oz.
Water 3 oz.
Ice 18 oz.
Pmp 8 oz.
Water 4 oz.
Ice 24 oz.
3 to 1
Pmp 3 oz.
Water 3 oz.
Ice 12 oz.
Pmp 4.5 oz.
Water 4.5 oz.
Ice 18 oz.
Pmp 6 oz.
Water 6 oz.
Ice 24 oz.
4 to 1
Pmp 2 oz.
Water 4 oz.
Ice 12 oz.
Pmp 3 oz.
Water 6 oz.
Ice 18 oz.
Pmp 4 oz.
Water 8 oz.
Ice 24 oz.
1 The product coming from the pump/port and the water for these drinks are automatically proportioned
to 1.5 times the “S” drink unless the proportions have been changed as in Section 8.1.0.
2 The product coming from the pump/port and the water for these drinks are automatically proportioned
to 2 times the “S” drink unless the proportions have been changed as in Section 8.1.0.
7.1.5 Place a jar in the blend station, press stop twice to exit the program mode,
then press S to select a small drink. Press 1to activate Drink (pump) 1
then press GO.
7.1.6 When the pump has stopped delivering product to the blender jar, you may
measure the product and get an actual dispense rate of the product from
pump number 1. E.g. If the volume of product in the jar is 4.4 ounces, 4.4
oz. / 4 seconds = 1.1 oz per second. Calculate the actual pump time by
dividing the required ounces by the actual pump rate. E.g. 4.0/1.1 = 3.6
Seconds. Record this number, it will be entered later. Re-enter the
programming mode (7-8-9-GO) and zero out Drink 1 Pmp 1.
7.1.7 Repeat Steps 7.1.1 to 7.1.6 for each pump port. You may use a different
concentration ratio in each pump and your formula may call for different
OWN-003 Model BDI Owner’s Manual – Blender Dispenser with Ice
16
To Next Page
Loading...