2
How to use K1 and Set motor Configuration Parameters:
1. Edit AutoSet.txt file on SD card over your computer (with SD card slot or over SD to USB
adapter, use Notepad or any simple text editor). Or skip this step and go with factory defaults.
2. Insert SD card (included in a package) with pins facing to USB-C connector
3. Power up K1 Flash over USB-C cable (run power from mobile phone, power bank – be careful here
– some power banks are turning off due to small K1 energy consumption, USB charger, USB computer
port ...) - Green LED starts to blink.
4. Unplug the main 5-pin CAN connector from your LCD display or disconnect connector
between LCD and motor. And connect to K1 Flash.
5. After few seconds motor is identified and parameters are set (the one which your motor
supports). Green LED change to steady - parameters are set successfully. You can disconnect
K1 Flash and connect back your display. Check for new speed limit under Info menu for
verification.
✓ LED will turn Red when AutoSet.txt does not exist.
✓ After each connecting to motor, K1 Flash will store your current controller settings into file CfgLog.txt
on SD Card.
To Next Page
Loading...