3
AutoSet.txt file print screen (located on SD card in Root):
# >>> Bafang CAN bus motor parameters settings file <<<
# >>> K1 Flash v1.3 M500,M510,M560,M600,M620 <<<
# *******************************************************
# This script will be executed after power up of K1 Flash with SD card inserted - Green LED is blinking.
# After connecting motor, device will setup your motor controller parameters (only what motor supports).
# Green LED steady - successfully set and you can disconnect K1
# Warning - Commands needs to be entered exactly, without
# any misstyping (first 5 characters are important). Otherwise device will ignore this line.
# Add "cage" # character to comment out whole line and disable the command.
# Activate this setup as following (order of first 2 steps matter):
# 1. Insert SD card in. (This file needs to be in root directory of SD card and FAT16 is needed).
# 2. Power on K1 Flash over USB-C (power bank, mobile, charger)
# 3. Connect to Bafang CAN motor (5 pin green connector
# with "house shape" - unplug from LCD display/buttons)
# 4. You can disconnect after few seconds - when LED goes
# steady Green - the following parameters are set:
# -----------------------------------------------------------------------------------------------
# >>>Following commands works with ALL Bafang CAN bus motors including Bafang CAN hub motors:
Speed=45
# Wheel size in inches - does not play any role on Bafang CAN
# controllers, just to show this info on display. For 27.5 put with dot.
Wheel=29
# Circumference of rear wheel in mm, motor is counting actual
# speed out of this number, check against GPS
Circumference=2230
# -----------------------------------------------------------------------------------------------
# >>>Following commands works with M510, M560, M820 motors:
# Global acceleration, 1 to 8, 8 is max acceleration. (M510 FC2.0 and M560 is ignoring this setting)
Acceleration=7
# How fast motor starts to assist on initial pedal turn, 0 to 13, 0 is fastest response
Startup Angle=1
# Max Current(Power) in % per each PAS level.
# Note: For M510 FC2.0 are defaults 50,75,100,100,100 - does make sense with Support level %
Max Current Map=20,32,46,72,100
# Max cadence in %
RPM Map=100,100,100,100,100
# -----------------------------------------------------------------------------------------------
# >>>Following commands works with M510 FC2.0, M560 motors:
# Torque multiplication to pedal torque, 0 to 500%
Support level Map=120,140,140,230,340
# Acceleration (starting phase currents or ramp up) per each PAS level, 1 to 8, 8 is max acceleration
Map Acceleration=5,6,7,7,8
# Startup angle in degree, if you have FC2.0 or M560 Startup Angle form previous section is ignored.
D StartUp Angle=10
# ------------------------------------------------------------------------------------------------
# Uncomment following command for Motor Calibration.
# Warning! Calibration will start in 5 second after
# connecting to motor (number 5 at the end). Make sure chain
# is down from chainring and you have battery charged!
#Calibration5
# ----------------------------------------------------------------------
# Note: You can run calibration by connecting over
# terminal to K1 Flash - free "Serial USB Terminal" application
# on Android phone. And also to set Speed, Circumference and Wheel
# over terminal:
# Example: s25 - Set Speed to 25 kmh
# c2220 - Set Circumference to 2220 mm
# w28 - Set Wheel size to 28 inch
# cal - Run Calibration. Put down chain before Calibration!
# >>> email: flash@K1eBikes.sk <<<
# >>> K1 eBikes, Slovakia <<<
To Next Page
Loading...