Kado - Lux Framed Shower Panel
- Use the correct type of drill bit for the material being drilled, with 6mm required
for anchor fixing and 3mm used for screwing directly into the wall studs.
- As with all toughened glass, take care while handling and wear safety goggles
and gloves for personal protection.
- Use of a non-acidic silicone is recommended.
Page 2 of 8
Important - Pre-Installation Instructions
Tools Required
- Please read this entire instruction book before commencing installation.
- A licensed tradesman must be used for the installation.
- Instructions to install a Shower Base with this Screen/Panel are included with the Base.
- These Shower Screens/Panels can also be installed directly onto a tiled floor.
- Ensure there is a gasket between all glass and metal components.
- Leave the plastic protectors on the glass corners until the last possible moment and
handle with care.
- In cold climates, warming the gaskets and seals with hot water or a hairdryer will
assist installation.
To Next Page
Loading...