92798 Cape Arago Hwy, Coos Bay, OR 97420 | 541-888-3517 | Toll Free 1-800-867-6863 | kksound.com
PURE CLASSIC
Thank you for buying the
Pure Classic
Transducer
System for your guitar! The Pure Classic is a four-head
piezo-ceramic transducer with endpin jack.
Please read through the complete instructions before
beginning installation.
This manual is written in great
detail to help you install the Pure Classic for best
possible performance. Please also familiarize yourself
with the handling instructions of the double-sided tape
and with the disclaimer at the end of this manual.
TABLE OF CONTENTS
1. Tools Needed
2. Package Contents
3. Removable vs. Permanent Installation
4. Installation Preparation
5. Installation for Guitars without Bridge
Reinforcement Strip
6. Installation for Guitars with Bridge
Reinforcement Strip
7. Drilling the Endpin Jack Hole
8. Installing the Endpin Jack
9. Removing the Pickups
1. TOOLS & SUPPLIES NEEDED
• Superglue gel
• Electric drill (for drilling endpin jack hole and
pickup reference hole)
• Proper drill bits for endpin jack mount and a
very small bit for the reference holes
• Pliers or wrench for endpin jack installation
• 4 latex gloves (if superglue is used,
alternatively use the supplied finger cots)
• Razorblade
To Next Page
Need help?
General
