Works, specified in “Technical maintenance” section, are to be regularily performed. If the the generator user has
no possibility to perform regular maintenance independently, it is necessary to address the official service center to
registrate an order for such works performance.
You can find a list of service center addresses in your warranty card.
If the DC protector turns off again, stop charging the battery because the charging current is too high.
Do not charge batteries if their current consumption is more than 5-8A (depending on the generator model).
In case of any damages, occurred due to non-performance
of regular maintenance works, the manufacturer bears no
responsibility for such damages.
IMPORTANT!
IMPORTANT!
- Be sure the ECON is turned off while charging the battery.
- Be sure to connect the red battery charger lead to the positive (+) batteryterminal, and connect the
black lead to the negative (-) battery terminal. Do not reverse these positions.
- Connect the battery charger leads to the battery terminals securely so that they are not disconnected
due to engine vibration or other disturbances.
- Charge the battery in the correct procedure by following instructions in the owner’s manual for
the battery.
- The DC protector turns off automatically if current above the rated flows during battery charging.
To restart charging the battery, turn the DC protector on by pressing its button to “ON”. If the DC
protector turns off again, stop charging the battery immediately and contact the point of sale.
Never smoke or interrupt battery connections to the generator
while the battery is being charged. Sparks can cause battery gas
to ignite. Battery electrolyte is poisonous and dangerous and
causes severe burns, as well as contains sulfuric acid.
Avoid contact with skin, eyes and clothing.
ATTENTION - DANGER!
TECHNICAL MAINTENANCE WORKS
8
SUCH DAMAGES ARE ALSO:
- Damages occurred as a result of using non original spare parts.
- Corrosion damages and other results of improper equipment storage.
- Damages occures as a result of maintanance performance by inexperienced and unauthorized specialists.
FIRST OF ALL THIS APPLIES TO:
- Use of lubricants, gasoline and motor oils, forbidden by the manufacturer.
- Device technical alterations.
- Equipment operations against its intended use.
- Indirect damages, caused by operating faulty equipment.
MANUAL COMPLIANCE
Technical maintanance, operation and K&S Basic™ generator storage
are to be performed according to this manual recommendations.
Manufacturer bears no responsibility for damages and losses,
caused by incompliance to safety requirements and technical
maintanance rules.
IMPORTANT!
www.ks-power.de/en | 25
To Next Page
Loading...