Supplied By www.heating spares.co Tel. 0161 620 6677
Remove the batteries from the printer if you are not planning to use the unit for a
long period of time.
The character is printed if information is lost because the printer cannot print fast
enough to keep up with incoming data. In order to prolong battery life please note
that it is suggested that you set the print contrast to the lightest readable setting and
ensure that the printer is turned off once you have finished printing.
OPTIONAL AC ADAPTOR
In order to prolong the battery life the printer will also operate with an optional AC
Adaptor (KMCU/IRP220)
CONTROLLING THE PRINT HEAD
If you turn the printer off whilst printing, the print head may stop in the middle of the
line. To return the print head to the left side of the paper, turn the printer on, then off.
MISSING OR MISFORMED CHARACTERS
The character will show on the print out if the printer has detected incorrect data
due to interference with, or interruption to, the stream of incoming information.
Common causes for this error include incorrect positioning of printer with reference
to the instrument (this can either be due to the distance or the angle of operation),
obstruction of the infrared signal or even interference from another infrared emitting
source.
ENVIRONMENTAL LIMITS
Operating temperature: 0
o
&to 50
o
C (32
o
F to 122
o
F)
Storage temperature: -40
o
& to 60
o
C (-40
o
) to 140
o
F)
Humidity: 5% to 95% relative at 40
o
C (104
o
)).
KMIRP
Infra-Red Printer
Kane International Limited
Kane House, Swallowfield
Welwyn Garden City
Hertfordshire
AL7 1JG
Tel: +44 (0) 1707 375550
Fax: +44 (0) 1707 393277
Stock No: 17810-2 July 2003
© Kane International Limited
To Next Page
Need help?
General