Kanex Premium Tempered Glass Screen Protector User Manual

Choose a clean, well-lit environment
with a flat surface.
Wash and dry your hands – Remove
dirt and oils.
Clean your screen – Use the provided
cleaning wipe to clean o the entire
screen. Then wipe the screen with the
microfiber cloth to remove all lint and
dust. Use the dust removal tape to
eliminate any remaining dust
particles. (DO NOT TOUCH THE
DEVICE SCREEN ONCE IT’S
CLEANED.)
Alignment:
Perfect alignment can be achieved by
following these easy steps.
Hold the sides of the glass with your
fingertips so the protective layer is
facing down. Peel o the protective
film labeled Step 1 . Do not touch the
adhesive side once the protective
layer is removed.
Slowly lower the uncovered adhesive
side to your screen while carefully
aligning it with the sides, bottom
and home button of your device.
If it does not align perfectly, gently
lift immediately and adjust until
you are satisfied.
Follow these steps to install your new Kanex Premium
Tempered Glass Screen Protector for iPhone SE / 6 / 6s /
6 Plus / 7 / 7 Plus / 8 / 8 Plus / X.
1
2
3
4
5
Installation Instructions
Preparation and Cleaning:
The first and most important step to a perfect installation.

Kanex Premium Tempered Glass Screen Protector Specifications

General

Brand	Kanex
Model	Premium Tempered Glass Screen Protector
Category	Cell Phone Accessories
Language	English

Summary

Preparation and Cleaning

Choose a clean, well-lit environment

Select a clean, well-lit area with a flat surface for optimal screen protector installation.

Wash and dry your hands

Ensure hands are clean and dry to prevent transferring dirt and oils to the screen.

Clean your screen

Use provided wipes and cloth to clean the screen thoroughly, removing all dust and lint.

Alignment

Hold and peel protective film

Hold the glass by its sides and peel off the protective film labeled Step ① without touching the adhesive.

Lower and align screen protector

Slowly lower the adhesive side, aligning it with the device screen's edges and home button.

Center tap and cross slide

Lightly tap the center of the applied protector and slide your finger across in a cross shape.

Bubbles

Eliminate bubbles

Use fingers and cloth to push bubbles towards the edges. Hold persistent bubbles for dissipation.

Finishing Touches

Polish screen protector

Use the microfiber cloth to polish the screen protector for a clean finish.

Important Notes