Kanto SYD - Connecting Audio Sources; Connecting a Turntable

7
Connecting Audio Sources
Connecting a Turntable
Use the appropriate audio cable to connect your audio source components to your speakers.
• 3.5 mm stereo mini-jack AUX cable
• Stereo RCA cable
• Optical Toslink cable
SYD supports data streams up to 24-bit/96 kHz resolution via Optical Toslink.
SYD features a built in Phono Pre-Amp that allows you to connect directly to a
turntable.
• connect your turntable to the RCA L/R inputs on the back of the SYD
• connect your turntable’s grounding wire to the grounding post (not all
turntables feature a ground wire)
• If your turntable does not have a built in Phono Pre-Amp, use the
“Phono” setting.
• If your turntable has a built in Phono Pre-Amp, use the “Line” setting.
ATTENTION
Some models of turntables include a built-in Phono Pre-Amp. If your turntable has a built in
Phono Pre-Amp, DO NOT use the Phono setting. Doing so will void your warranty and could
cause severe damage to your speakers.
Sub Out
L
R
RCA
RCA
USB Charge
5V/1000 mA
ON OFF
POWER
AUX
OPT
GND
RCA AUX OPT
RCA
Phono
Line