Kanto SYD - Special Functions; Sub Mute; Automatic Power Up (APU); Automatic Power Down (APD)

9
Automatic Power Up (APU) / Automatic Power Down (APD) - SYD is designed to save
power when not in use. When no audio signal has been detected for 15 minutes, the SYD
Amp will put itself into stand-by mode (APD). If the audio signal returns via the same input
that the SYD was playing when it entered standby, the SYD will wake up and resume playing
(APU). It can also be woken up manually by:
• Pressing the Standby Button on the Remote
• Pressing the Control knob
If you do not nd the APU feature useful, you can disable it by pressing the Balance Reset
button on the remote and holding it for 5 seconds. The Status LED will blink once to
indicate that you have disabled the APU feature. To enable APU if you have disabled it,
simply press and hold the Balance Reset button again for 5 seconds. The Status LED will
blink twice to indicate that you have enabled APU.
If you do not nd the APD feature useful, you can disable it by pressing the Bass Reset
button on the remote and holding it for 5 seconds. The Status LED will blink once to
indicate that you have disabled the APD feature. To enable APD if you have disabled it,
simply press and hold the Bass Reset button again for 5 seconds. The Status LED will blink
twice to indicate that you have enabled APD.
Special Functions
SYD Stand
Sub Mute - You can disable/enable the sub output on SYD. This can be helpful in situations
where you want to listen to your speakers but don’t want to disturb the neighbours with
sub-bass.
To mute the sub output, press and hold the Mute button for 5 seconds. You will see two
LED blinks to conrm the sub output is muted. To un-mute the sub output, press and
hold the Mute button again for 5 seconds. You will see one LED blink to conrm that the
sub output has been un-muted. The sub output will be reactivated upon waking up from
standby.
ATTENTION
APU/APD is always enabled when power is applied, but APU will only activate after APD has been
triggered. APU will not work if the unit is manually switched to standby using the remote or
control knob.
ATTENTION
APU function will not work when using the Bluetooth input.