22 |
B: Installation:
1. Unpack the on-board device and place
it in the bracket as shown in the gure (B1).
2. Before installing the on-board unit, clean the inside
surface of the windscreen using the cleaning tissue
supplied (B2).
Attention!
The designated area for mounting the on-board unit
is at the bottom part of the inside windscreen
between the centre of the vehicle and the steering
wheel. It is prohibited to place any objects within the
driver’s visual eld that would hamper the driver’s
view in any direction.
The windscreen wipers in the resting position should
not obstruct the on-board unit.
If the vehicle has any structural elements hanging
over the windscreen (e.g., an excavator bucket,
a crane boom, a visor, a protruding van or in case
the wipers are located atypically), refer to the
Supplement to the User Manual on the last page.
The driver of the vehicle is responsible for the correct
installation of the on-board unit!
To Next Page
Loading...