How to start Kärcher Floor Machine?
To start the Kärcher Floor Machine: 1. Turn the key-operated switch to "1". 2. Actuate the safety switch. 3. Insert the battery plug. 4. Check the battery and charge if necessary. 5. Check that the battery terminals are correctly connected.
What to do if suction performance is too low on Kärcher Floor Machine?
If the suction performance of your Kärcher Floor Machine is too low, take the following steps: 1. Shut down the device and drain the waste water. 2. Clean the seals between the waste water tank and the cover, check for leaks and replace if necessary. 3. Check that the suction hose is correctly connected to the waste water tank. 4. Check the fluff filter for soiling and clean if necessary. 5. Clean the suction lips at the suction bar, turn over or replace if necessary. 6. Check that the cap on the waste water drain hose is closed. 7. Check the adjustment of the suction bar. 8. Check the suction hose for clogging and clean if necessary. 9. Check the suction hose for leaks and replace if necessary.
What to do if the water volume is insufficient in Kärcher Floor Machine?
If the water volume of your Kärcher Floor Machine is insufficient: 1. Check the fresh water filling level and fill the tank if necessary. 2. Increase the water volume at the water volume regulating knob. 3. Clean the fresh water filter. 4. Check the hoses for clogging and clean if necessary.
Why are the cleaning results unsatisfactory with my Kärcher Floor Machine?
If you are experiencing unsatisfactory cleaning results with your Kärcher Floor Machine, consider the following: 1. Reduce the driving speed. 2. Check the brushes for wear and replace if necessary. 3. Check the suitability of the brush type and detergent used.
What to do if the suction turbine runs at an increased speed in Kärcher Floor Machine?
If the suction turbine in your Kärcher Floor Machine runs at an increased speed: 1. Drain the waste water. 2. Clean the float. 3. Check the fluff filter and clean if necessary. 4. Check the suction hose for clogging and clean if necessary. 5. Check the suction bar for clogging and remove any clogging if necessary.
What to do if the brushes do not rotate on the Kärcher Floor Machine?
If the brushes on your Kärcher Floor Machine do not rotate, check if the brushes are blocked by a foreign body and remove the foreign body if necessary.
General| Power Source | Battery |
|---|---|
| Working Width, Brush | 510 mm |
| Working Width, Vacuum | 900 mm |
| Tank Capacity (Clean Water) | 55 l |
| Tank Capacity (Dirty Water) | 55 l |
| Brush Speed | 180 rpm |
| Drive Type | Manual |
| Voltage | 24 V |
| Battery | 24 V |
| Brush Pressure | Adjustable |
| Brush Motor Power | 750 W |
To Next Page