English 25
The rollers are dirty.
Clean the rollers.
Rollers are not being sufficiently mois-
tened.
Moisten the rollers by moving back
a
nd forth over the same position.
Incorrect detergent or incorrect dos-
age.
Use only KÄRCHER detergent and
be sure to use the correct dosage.
Foreign detergents are present on the
floor.
Remove all detergent residues from
the
rollers using water.
Clean the floor several times using
the device and clean rollers, with
out
u
sing detergent. This removes de-
tergent residues from the floor
Rollers are blocked.
Remove rollers and check if an ob-
ject has become stuck in the rollers.
Check that the rollers are screwed
in
as far as they will go onto the roll-
er holder.
Check that the floor head cover is
c
orrectly seated. For this, remove
the cover and then
fit it back in
p
lace.
Floor head cover not installed correctly
Check that the floor head cover is
corre
ctly seated. For this, remove the
cover and then fit it back in place.
The rollers are worn out.
Replace the rollers.
Waste water tank is overfilled.
Empty the waste water tank right
away.
Waste water tank does not fit properly
in the appliance.
Check that the floor head cover is firm-
ly seated on the waste water tank.
Check that the waste water tank
flap
s are correctly closed.
ATTENTION
Do not remove handle from the device
once assembled.
The handle may only be removed for
shipping service purposes.
Insert screwdriver at a 90 degree
an
gle in small opening at rear of de-
vice and simultaneously pull hand
le
up until it slides
off.
ATTENTION
Please ensure cord between body and
handle are not damaged.
Pull carefully to avoid damaging the
device.
Poor cleaning result
Rollers do not turn
Water pick up not optimum
Appliance is leaking waste water
Removing handle from device