6 English
Screwdriver, small size (not supplied)
Î STEP 1:
Attach the handle to the frame of the
pressure washer. Align hole, insert
bolt, and tighten with knob.
Î STEP 2:
Push out the safety clip in the trigger-
gun using a small screwdriver.
Join high pressure hose and trigger-
gun together.
Push clip in until it locks and check
that it is securely fastened by pulling
on the high pressure hose.
Î STEP 3:
Insert the spray wand into the trigger
gun. Carefully press in against the
spring tension and twist into the
locked position.
CAUTION
Do not run the engine with a high or low
oil level as this can cause engine dam-
age.
If you have further questions regarding
the engine, please refer to the engine
manual included with the unit.
Î STEP 1:
Check oil level. Oil level should al-
ways be between the “FULL” and
“ADD” marks on the dipstick.
Be sure the machine is level when
checking the oil level. (Refer to the
engine’s operating manual for sea-
sonal grades.).
We recommend that the oil be
changed after the first 5 hours of
use, then once every 25 hours.
Î STEP 2:
Fill gas tank with unleaded gasoline.
Do not use leaded gasoline.
Î STEP 3:
Connect the high pressure hose to
the unit’s high pressure outlet.
Î STEP 4:
Connect garden hose to unit’s water
inlet.
Î STEP 5:
Connect garden hose to the cold wa-
ter source and turn water on com-
pletely.
Do not use hot water.
ASSEMBLY INSTRUCTIONS
Required tools
OPERATING INSTRUCTIONS
To Next Page
Loading...
