3. Open water source.
4. Start the Engine.
Starter cord rapid retraction can
result in Serious injury. Rapid
retraction will pull hand and arm
towards engine faster than you can
let go. Always relieve spray gun
pressure before pulling starter
cord. Pull starter cord slowly until
resistance is felt, then pull rapidly.
► STEP 1: Turn the engine switch to
"ON" position.
► STEP 2: Move choke lever to
"CLOSE" position.
► STEP 3: Turn the fuel valve to
"ON" position.
► STEP 4: Put the throttle lever to the
"FAST" position.
► STEP 5: Pull trigger on spray gun to
release pressure.
► STEP 6: Locate recoil cord and pull
slowly until resistance is felt. At this
point, pull rapidly to start engine.
► STEP 7: After the engine has started,
turn the choke lever to "OPEN"
position.
NOTE: If unable to start the engine,
repeat the above operation one or two
times.
NOTE: If the temperature is higher,
such as during summer or if the engine
is hot, choke valve should be switched
to "OPEN" position before starting.
Cleaning Procedure:
Position the tip of the wand 15-20 cm
(6”-8”) away from the surface to clean
at a 45°angle.
To Next Page
Loading...
Need help?
General
