Always relieve spray gun pressure
before pulling starter cord. Pull starter
cord slowly until resistance is felt, then
pull rapidly.
► STEP 1: Turn the engine switch to
"ON" position.
► STEP 2: Move choke lever to
"COLD START" position.
► STEP 3: Turn the fuel valve to "ON"
position.
► STEP 4: Put the throttle lever to the
"FAST" position.
► STEP 5: Pull trigger on spray gun to
release pressure.
► STEP 6: Locate recoil cord and pull
slowly until resistance is felt. At this
point, pull rapidly to start engine.
► STEP 7: After the engine has started,
turn the choke lever to "RUN" position.
NOTE: If unable to start the engine,
repeat the above operation one or two
times.
NOTE: If the temperature is higher,
such as during summer or if the engine
is hot, choke valve should be switched
to "RUN" position before starting.
Cleaning Procedure:
Position the tip of the wand 15-20 cm
(6”-8”) away from the surface to clean
at a 45°angle.
Starter cord rapid retraction can result
in Serious injury. Rapid retraction will
pull hand and arm towards engine
faster than you can let go.
To Next Page
Loading...
