Kärcher K 3 Full Control User Manual

English 17
Illustrations on the picture pages
 Illustration
Mount loose parts delivered with appli-
ance prior to start-up.
 Park the appliance on an even surface.
 Illustration
Push the high pressure hose into the
trigger gun until it locks audibly.
Check the secure connection by pulling
on the high pressure hose.
 Illustration
ATTENTION
Impurities in the water can damage the
high-pressure pump and the accessories.
For protection, the use of the KÄRCHER
water filter (optional accessory, order no.
4.730-059) is recommended.
몇 CAUTION
Dry running of more than 2 minutes leads to
damage of the high-pressure pump. If the
appliance does not build up pressure within
2 minutes, switch the appliance off and pro-
ceed in accordance with the instructions in
Chapter "Troubleshooting".
몇 CAUTION
Keep a distance of at least 30 cm when us-
ing the jet for cleaning painted surfaces to
avoid damage.
ATTENTION
Car tyres, paint or sensitive surfaces such
as wood should not be cleaned with the dirt
blaster, as there is a risk of damage.
 Illustration
The pressure indicator on the trigger gun
shows the currently set pressure level dur-
ing operation with a Full Control spray
lance.
Note: The pressure indicator is not signifi-
cant during operation with the T-Racer and
other accessories.
ATTENTION
The sensitivity of the materials can strongly
differ depending on the age and the condi-
tion. The so-called recommendations are
non-binding.
Note: Detergent can only be added when
the device is operated in low pressure
mode.
 Illustration
 Spray the detergent sparingly on the
dry surface and allow it to react, but not
to dry.
 Spray off loosened dirt with the high
pressure jet.
 After operation with detergent: Run the
machine for approximately 1 minute for
a clear rinse.
Installation and Startup
Operation
High pressure operation
Full Control System
Pressure
level
For example,
recommended for
HARD Stone terraces made of
paving stones or exposed
aggregate concrete, as-
phalt, metal surfaces, gar-
den utensils (wheelbarrow,
spade, etc.)
MEDIUM Motorcar / motorcycle, brick
surfaces, plastered walls,
plastic furniture
SOFT Wooden surfaces, bicycles,
sand stone surfaces, rattan
furniture
MIX Operation with detergent
Operation with detergent
Recommended cleaning method
After operation with detergent

Kärcher K 3 Full Control Specifications

General

Flow rate	380 L/h
Max water feed temperature	40 °C
Power	1.6 kW
Area performance	25 m²/h
Weight	4.4 kg
Max Pressure	120 bar
Water Flow	380 L/h
Motor Power	1.6 kW
Weight without accessories	4.4 kg
Hose Length	6 m
Detergent Tank Capacity	0.5 L
Power Cord Length	5 m
Pressure	20-120 bar