To Next PageTo Next PageWhat to do if High/Low pressure nozzle leaks on Kärcher K2.35 Pressure Washer?
If your High/Low pressure nozzle is leaking on your Kärcher Pressure Washer, ensure the High/Low pressure nozzle is properly attached into the trigger gun by carefully pressing it in against the spring tension and twisting it into the locked position. If the problem persists, call Customer Service.
How to troubleshoot a Kärcher Pressure Washer when the motor will not start?
If your Kärcher Pressure Washer motor won't start, first ensure the On/Off switch is in the “ON” (I) position. Next, check if the power cord is properly plugged in. If you're using an extension cord, make sure it's either a 25 ft. 12/2 gauge or a 50 ft. 10/2 gauge cord. Finally, try a different electrical outlet to rule out inadequate power supply.
Why is my Kärcher K2.35 not reaching high pressure?
If your Kärcher Pressure Washer isn't reaching high pressure, ensure you're using a 1/2 inch or 5/8 inch garden hose. Check the garden hose for any kinks, leaks, or blockages that might be restricting the water supply. Open the water source fully to ensure adequate inlet water supply. Also, inspect the water inlet filter for clogs and rinse it out in warm water if needed. Finally, make sure the High/Low pressure nozzle is set to the high pressure position.
What to do if the output pressure varies high and low on my Kärcher Pressure Washer?
If the output pressure of your Kärcher Pressure Washer varies, ensure the water is turned on full force and check the garden hose for kinks, leaks, or blockages. Inspect hoses and fittings to ensure they are airtight. If the pump is sucking air, turn off the machine and purge the pump by squeezing the trigger gun until a steady flow of water emerges through the nozzle. Clean the water inlet filter by removing it and rinsing it in warm water. Clear any obstructions from the discharge nozzle using a fine needle. For calcified components, run distilled vinegar through the detergent tank.
Why is my Kärcher K2.35 Pressure Washer not dispensing detergent?
If you're not getting any detergent from your Kärcher Pressure Washer, try diluting the detergent if it's too thick. Check the filter on the detergent suction tube for clogs and rinse with warm water to remove any debris. Inspect the detergent suction tube for damage or clogs; remove any obstructions or replace the tube if necessary. Ensure the High/Low pressure nozzle is in the low pressure position. Also, make sure the discharge nozzle is not obstructed; if it is, blow out or remove debris with a fine needle.
How to fix garden hose connection leaks on Kärcher Pressure Washer?
If you notice leaks from the garden hose connection on your Kärcher Pressure Washer, begin by tightening the fittings. If the leak persists, check for a missing or worn rubber washer and insert a new one.
Why is the pump on my Kärcher K2.35 Pressure Washer so noisy?
If your Kärcher Pressure Washer's pump is making unusual noises, it might be sucking air. Ensure that all hoses and fittings are airtight. Turn off the machine and purge the pump by squeezing the trigger gun until a steady flow of water emerges through the nozzle.
What causes water to leak from the pump of my Kärcher K2.35?
Check that all fittings are tight if water leaks from the pump of your Kärcher Pressure Washer. If the problem persists, call Customer Service, because water seals may be damaged or worn.
What should I do about an oil drip from my Kärcher K2.35?
Call Customer Service if you notice an oil drip from your Kärcher Pressure Washer, because oil seals may be damaged or worn.
General| Flow Rate | 360 l/h |
|---|---|
| Hose Length | 4 m |
| Voltage | 220-240 V |
| Pressure | 110 bar |
| Frequency | 50 Hz |
General safety guidelines for using the pressure washer, including handling high-pressure jets and electrical safety.
Proper grounding procedures to prevent electric shock by using a grounded outlet and plug.
Guidelines for selecting and using appropriate extension cords for outdoor use.
Requirements for water supply, including hose diameter, flow rate, and temperature.
Explanation of the two pressure settings (high/low) and how to adjust them.
Instructions for taking short breaks during operation, including engaging the safety lock.
Procedure for cleaning the water inlet filter by rinsing it in warm water.
Procedure for cleaning the detergent suction tube filter in warm water.
Guidance on cleaning decks, including detergent application and rinsing techniques.
Instructions for cleaning house siding, emphasizing detergent application and rinsing.
Methods for cleaning patios, brick, and stone surfaces with the pressure washer.
Steps for cleaning vehicles like cars, boats, and motorcycles using the pressure washer.
Cleaning tips for grills, power equipment, and garden tools.
Guidance on cleaning outdoor furniture and lawn items.
Information on available optional cleaning accessories.
