English 9
20 Angle piece
21 Cartridge filter (PES)
22 Securing nut
23 Suction pipe holder
24 Mains cable
25 Type plate
26 Cable hooks
Preparation
1. Unpack the device and install the
accessories.
Illustration B
Initial startup
ATTENTION
Danger due to fine dust entering
Risk of damage to the suction motor.
Never remove the cartridge filter when
vacuuming.
Dry vacuuming
● An additional fleece filter bag can be
used when vacuuming fine dust.
Installing the fleece filter bag
1. Unlock and remove the suction
head.
2. Fit the fleece filter bag.
Illustration C
3. Fit and lock the suction head.
Wet vacuum cleaning
Installing the squeegees
1. Remove the brush strip.
Illustration D
2. Install the squeegees.
Note
The structured side of the squeegees
must face outwards. Note the different
lengths of the squeegees.
Removing the fleece filter bag
● The fleece filter bag must always be
removed when vacuuming wet sub-
stances.
1. Unlock and remove the suction
head.
2. Pull the fleece filter bag on the
flange up and out.
Illustration E
3. Fold in the lock latch and seal the
fleece filter bag tight.
4. Fit and lock the suction head.
General
● We recommend not using the
"Semi-automatic filter dedusting"
function button when vacuuming
wet dirt with the crevice nozzle or
upholstery nozzle (optional) when
sucking mainly water out of a con-
tainer.
● On completion of wet vacuum clean-
ing: Clean the cartridge filter using
the filter dedusting function. Clean
the container with a moist cloth and
dry it off.
Clip connection
The suction hose is equipped with a
clip system. All accessory parts with a
nominal width of 1.38 in (35 mm) can
be connected.
Illustration F
Operation
Main switch
Switching on the device
1. Connect the mains plug.
2. Set the main switch to the desired
program.
Device OFF
Device ON
Semi-automatic filter de-
dusting: ON
Socket: OFF
Device ON
Semi-automatic filter de-
dusting: ON
Socket: ON
To Next Page
Loading...
Need help?
General
