Kärcher SC 4.100 CB User Manual

English 9
 Danger
Hot water may drip out of the accessory
parts while you are detaching them! Never
detach accessory parts while steam
streams out - risk of scalding!
 Move the selector switch for the steam
volume back (steam lever locked).
 Illustration
To detach the accessory parts, press
the unlocking button and pull the items
apart.
The water reservoir may be refilled at any
time.
Caution
Do not use condensation water from the
drier!
Do not fill with detergent or other additives
(for example fragrances)!
Do not use pure distilled water! Max. 50%
distilled water and 50% tap water.
Do not use collected rain water!
 Illustration
You can remove the water reservoir to fill it
or you can fill it directly on the appliance.
 Pour water from a container into the
funnel inlet. Fill up to the "MAX" mark-
ing.
 Pull the water reservoir straight up.
 Fill the water reservoir up to the "MAX"
marking while positioned vertically un-
der the water tap.
 Insert the water reservoir and press
downwards until it arrests.
 Place the unit securely on a firm sur-
face.
 Insert the mains plug into a socket.
 Press the ON/OFFswitch to turn on the
appliance.
Indicator lamp "heating on" is blinking
(green)
Note: If there is no or not enough water in
the steam boiler, the water pump starts and
supplies water from the reservoir into the
steam boiler. The filling process may take
several minutes.
 Wait until the indicator lamp (heater)
lights up permanently.
The steam cleaner is ready to use.
Note: The appliance closes the valve every
60 seconds. This prevents the calcifying of the
appliance. There will be a slight audible click.
The steam delivery is not impaired by this.
In case of water shortage, the indicator
lamp "water shortage" glows red in the wa-
ter reservoir and a signal can be heard.
Note: Every time there is not enough water
in the steam boiler, the pump automatically
supplies water from the water reservoir into
the steam boiler. If the water reservoir is
empty, the water pump is not able to fill the
steam boiler and the steam tapping is
blocked.
 Fill the water reservoir up to the "MAX"
marking.
Note: The water pump tries to fill the steam
boiler in short intervals. If the filling is suc-
cessful, the steam tapping is released im-
mediately, and the red indicator lamp goes
out.
Removing the accessories
Filling the water reservoir
Directly on the appliance
Take off water reservoir
Turning on the appliance
Refilling water

Kärcher SC 4.100 CB Specifications

General

AC input voltage	220 - 240 V
Type	Cylinder steam cleaner
Capacity	1 L
Ready time	3 min
Steam pressure	3.5 bar
Soft grip	Yes
Dimensions (WxDxH)	241 x 384 x 275 mm

Weight and Dimensions

Weight	4200 g