Kärcher WD 2 Plus - Finishing operation; Care and service; Cleaning foam filter; cartridge filter

English 11
Finishing operation
1. Set the power switch to "0 OFF".
The device is switched off.
2. Pull out the mains plug.
3. Remove the device head.
4. Empty the container.
5. Storage possibility:
Note
The suction hose can be wrapped
around the device head and attached
to the device head with the help of the
hose collar.
6. Store the device in a dry and frost-
proof room.
Care and service
General care instructions
 Maintain the device and the plastic
ac
cessories with a commerci
ally
a
vailable plastic cleaner.
 If necessary, rinse the container and
accessories with water and dry them
before reuse.
Cleaning foam filter / cartridge
filter
1. The foam filter / cartridge filter can
b
e cleaned under running water
if
n
ecessary. To do this, pull the foam
filter off the filter basket. The car-
tridge filter can be unlocked and re-
moved by turning it in th
e
dir
ection of the symbol.
2. Do not rub or brush off the foam filter
/ cartridge filter during cleaning.
3. Allow foam filter / cartridge filter to
dry completely before reuse.
4. Reinserting the filter depending
on
the
type of application:
 Foam filter: Put the filter over th
e
filter
basket and make sure that
it
is pr
operly fixed.
 Cartridge filter: Mount the filter
on
th
e filter basket and turn it in th
e
dir
ection of the symbol and en-
sure correct fixation.