To Next PageTo Next Page
Need help?Do you have a question about the Kärcher Windsor Chariot 2 iScrub 20 and is the answer not in the manual?
General| Brush speed | 180 RPM |
|---|---|
| Recovery system | Vacuum |
| Battery voltage | 24 V |
| Working width, brush | 51 cm |
| Water tank capacity | 20 l |
| Recovery tank capacity | 20 l |
| Area performance theoretical | 1530 m²/h |
| Area performance practical | 1, 000 m²/h |
| Charging time | 8 h |
| Dimensions (L x W x H) | 1, 100 x 610 x 1, 100 mm |
Hazards or unsafe practices that could result in severe personal injury or death.
Hazards or unsafe practices that could result in minor personal injury or property damage.
Actions that must be followed for safe operation of equipment.
Controls the power for machine functions.
Cuts all power to the machine and applies parking brake.
Ensures safe propel drive engagement and controls direction.
Controls vehicle speed via selected speed control setting.
Activates the horn by pressing the button.
Turns front wheel to change machine direction.
Controls maximum speed with two settings: slow and fast.
Indicates battery charge level; flashing indicates charging needed.
Records machine hours for service determination.
Selects operating modes like Light cleaning, Deep cleaning, Vacuum only, etc.
Describes various cleaning modes like vacuum only, double scrub, and finish removal.
Controls the rate at which solution is delivered to the scrub deck.
Inspection steps to identify potential problems before operation.
Steps to safely start the machine.
Procedure to activate the emergency stop and parking brake.
Instructions for filling the solution tank safely.
Planning the scrubbing pattern and efficient operation.
Step-by-step guide to start the scrubbing process.
Steps to safely stop the machine's scrubbing operation.
How to perform a double scrub for heavily soiled floors.
How to remove floor finish using a chemical-free mode.
Explains the selection switch for chemical dilution rates.
Maintenance guidelines for the Delta Q IC650 charger.
How to operate and understand the Delta Q IC650 charger.
Process for selecting and confirming charger profiles.
Steps to configure the charger via USB.
How to retrieve charge data using a USB flash drive.
Instructions for replacing or rotating squeegee blades.
Specifics on squeegee blades for cylindrical models.
How to adjust squeegees for optimal contact and clearance.
Diagram and labels for the disk scrub deck.
Diagram and labels for the cylindrical scrub deck.
Diagram and labels for the orbital scrub deck.
Brush options for disk machines from light soil to polishing.
Brush options for orbital machines on finished floors.
Brush options for cylindrical machines.
Pads for finish removal mode on orbital models.
Brush types for different floor finish types and applications.
Steps for replacing disk scrub brushes and pads.
Steps for replacing orbital scrub pads.
Steps for replacing cylindrical scrub brushes.
How to remove or install the debris bin on cylindrical models.
Steps to replace the brush motor on disk models.
Steps to replace the brush motor on orbital models.
Steps to replace the brush motor on cylindrical models.
Steps for removing and replacing the scrub deck actuator.
Information on circuit breakers and their function.
Location and cleaning of the solution strainer.
Location and operation of the solution shut-off valve.
Location and replacement of the solenoid valve.
Drive motor carbon brush replacement for specific serial numbers.
How to adjust the drive chain tension.
Information on engaging/disengaging drive gear for transport.
Steps to disengage the brake for manual movement.
Procedure for navigating inclines.
Drive motor carbon brush replacement for earlier serial numbers.
How to adjust drive chain tension.
Information on pushing or towing the machine.
How to engage the drive gear for driving.
How to disengage the drive gear for pushing/towing.
Procedure for navigating inclines.
Recommended points and methods for securing machine.
Tie-down points for deluxe models during transport.
