To Next PageTo Next Page
Need help?Do you have a question about the Kärcher Xpert HD 7125 and is the answer not in the manual?
General| Form factor | Upright |
|---|---|
| Hose length | 10 m |
| Power source | Electric |
| Product color | Black, Grey, Yellow |
| Maximum pressure | 160 bar |
| Maximum flow rate | 480 l/h |
| Working pressure (max) | 130 bar |
| Maximum input water temperature | 60 °C |
| Auto power off | Yes |
| AC input voltage | 230 V |
| AC input frequency | 50 Hz |
| Power consumption (typical) | 2300 W |
| Surface cleaner | - |
Weight and Dimensions| Depth | 360 mm |
|---|---|
| Width | 375 mm |
| Height | 925 mm |
| Weight | 22000 g |
Read and comply with original instructions prior to initial operation and follow safety indications.
Check oil level is correct. Activate deaeration of oil container by removing and refitting hood.
Connect to a properly installed electrical supply matching type plate voltage. Check power cord for damage.
Connect supply hose, open water supply. Use system separator for drinking water protection.
Do not spray flammable liquids. Clean engines at designated locations with oil separators.
Motor starts when trigger is pulled. Set switch to 'I', unlock spray gun, adjust pressure/flow.
Use approved detergents. Suspend detergent hose, set nozzle to 'CHEM', adjust dosing for concentration.
Disconnect power plug before any tasks. Risk of injury from startup or shock.
Disconnect power plug before troubleshooting. Use authorized service for repairs.
